![]() Problem persists repeat the procedure once more or twice to be sure.īluetooth models are also equipped with a remotely controlled system, where youĬan reboot using an application installed on your phone. The device is now ready for use, press the power button once to turn it on, it is now safe to drive, so long as it does not show any red lights or irregular beeping.Wait for about 10 seconds, keep the device still and press the power button once to shut it down.Ensure that the device remains stationary until the reset process is complete. The device now factory resets itself, you will notice flashes on the Bluetooth and fore lights.The device Bluetooth function turns on and the speakers will notify you. Press the power button for about 5-10 seconds, do this carefully to prevent moving the hoverboard or tilting it.Ensure that the device does no tilt on the surface, tilting the device while resetting might force you to repeat the process.Align the two pads, check that the middle part aligns this is seen when the two pads lock, parallel to each other.Place the hoverboard on a flat surface, ensure that the ground is parallel, the floor of your house can work or a countertop if you don’t intend to bend over.To ascertain that the device is completely off by turning it on and then off and wait until it beeps and the lights stop showing. Do not use the remote as it will only render the device into sleep mode. Use the on/off silver button on the sides of the hoverboard. Disconnect any Bluetooth devices or audio device that is connected to your hoverboard.Charge the hoverboard for about 2 – 3 hours or until it is fully charged.The only problem with resetting a Bluetooth hoverboard is, you might fry the Bluetooth chip, regardless of whether you do it right or wrong. Resetting a Bluetooth hoverboard is just a walk in the park, I mean it is not rocket science, everyone can do it, so long as they follow these simple manual steps. This can be a continuous red light, lack of balance, difficulty when turning or stopping.Ī faulty hoverboard will have the fault red light on, shakes violently when riding, or getting off and might be difficult to make turns, or is super sensitive and make fast turns. Like all devices, it will malfunction after successive use or rough handling, and does not feel the same again. The Bluetooth function turns on automatically when you turn on the device and remains discoverable until you connect to your phone. A Bluetooth hoverboard resembles the common hoverboard the only difference is it possesses a Bluetooth receiver module and speakers that allow you to play music.
0 Comments
Leave a Reply. |